[Ardour-Users] trouble with retaining microphone connectivity over multiple sessions in Ardou

Paul Davis paul at linuxaudiosystems.com
Wed Jun 24 05:03:36 PDT 2015


On Tue, Jun 23, 2015 at 10:15 PM, Cameron Metcalf <podeas at gmail.com> wrote:

> Paul,
> I re-traced my steps. I had definitely read through:
> http://jackaudio.org/faq/device_naming.html
> a few times this past week and tried out (and have just RE-tried) the
> following (after each change below, I re-run qjack and boot up Ardour to
> see if the mic can be found)...
>
> I run: cat /proc/asound/cards
>
> and get:
> 1 [VSL            ]: USB-Audio - AudioBox 22 VSL
>                       PreSonus AudioBox 22 VSL at usb-0000:00:1d.7-3, high
> speed
>
> --
>
> The conclusion of the FAQ page informs: "You can type it into the device
> name selector in the upper left of qjacktl's setup dialog."
>
> I do not see anyplace in qjacktl where I can literally type in a device
> name selector. (I uninstalled an reinstalled qjacktl to try and look for
> this again in case anything had been botched from other things I'd changed).
>
> After I click "setup" from qjacktl there is no place to type in a device
> name selector. However, in the "Settings" tab, there are two dropdown boxes
> for INPUT and OUTPU.  Both literally have "> hw:VSL" selected already.
>

You should NOT use the INPUT or OUTPUT selectors. They should never have
been displayed so prominently. You need the "Interface" selector near the
upper right of the setup dialog.


>
> Out of desperation and just to see what would happen, I ran: jackd -d
> alsa -d hw:VSL
> from the command line. This did not resolve the problem.
>

Well, that's correct. So I think you need to restate the problem ....
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ardour.org/pipermail/ardour-users-ardour.org/attachments/20150624/b1c6be95/attachment.htm>


More information about the Ardour-Users mailing list