Hi everybody,<br>
I've been a long time reader and seldom poster on the ardour
list.  I have been using ardour in a very minimal way just for
composing music with synths and recording into ardour with jack. 
Now I am about to move into the big leagues and buy a live PA/recording
hybrid system and I want to use ardour to record both live and studio
work.  Basically I want to make sure that during live recording
that NO MATTER WHAT, ardour doesn't crash....as the recordings (which
are mainly conferences and seminars) will be produced and sold. 
Below is the system I'm using to start off until I can get more gear.<br>
<br>
Mixer: Behringer DDX3216 with ADAT expansion<br>
Soundcard: RME HDSP9652<br>
Video Card: NVIDIA FX5700 with proprietary drivers (My own)<br>
PC:  Intel Pentium 4 2.66GHz 512MB RAM, Asus motherboard (PS4SGX), with onbard SiS video (currently disabled)<br>
(This is my own PC to start with so I'm planning on buying a second
250GB Hard drive to separate my personal install (FC4) from dedicated
audio
install)<br>
Software: Fedora Core 3 with CCRMA setup/low latency etc etc.<br>
<br>
I am using fedora as at that is what I know best.  I use FC4
currently but I know it is not stable enough to run ardour
properly...is FC3 okay?  I read that I should be using the 2.4
Kernel for best stability.  So is it cool to downgrade the FC3
kernel to 2.4? or should I get FC2?<br>
<br>
Does anybody know if the NVIDIA card will cause instability or try and
hog too many resources?  Should I just use my onboard video?<br>
<br>
Also I thought getting an external USB 2/firewire Hard Drive might be
handy instead of an internal, but I don't really trust it's speed or
stability over an internal SATA drive.  I would also only do this
if there was a way I could boot off the external (ie keeping the whole
OS and audio storage on the same drive for the ability to use other
computers if need be).<br>
<br>
Also, I know that the mixer has automated/motorised faders which
interfaces with Steinbergs Cubase.  Would that be just using the
MMC protocol? Could I hook it up to interface with ardour?<br>
<br>
Any comments, advice, suggestions would be muchly appreciated...I will be ordering the stuff in the next few days.<br>
<br>
Cheers,<br>
Andrew Johnston<br>