[Ardour-Users] Peak levels on master bus vs single track
robin at gareus.org
Thu Mar 2 12:39:12 PST 2017
On 03/01/2017 09:47 PM, Alf Haakon Pietruszka Lund wrote:
> I just finished a project in Ardour 4.7.0 on Ubuntu Studio 14.04
> There are several regions in many tracks, some of them overlapping in
> time, most of them not.
> On most of the tracks I used a compressor and a limiter (both from calf)
> to avoid peaks and potential clipping. I set the limiter's output gain
> to minus 2.2 dB.
> As expected, when focused on one of the tracks, the meter doesn't pass
> -2.2 dB.
> However, when focused on the master bus, the meter 'clips' and peaks at
> +0.9 dB.
The signal level of a sum of 2 signals may be higher (up to 6dB in case
of 2 signals) or it may be lower in case some parts cancel each other out.
If you sum two tracks both having the same sine-wave at -6dBFS, the
result (on master) is 0dBFS .
You really want a limiter on the master-bus (not on individual tracks)
As far as free software goes, I'd use swh's fast-lookahead-limiter.
 well, in Ardour's case using mono tracks, the panner will distribute
L/R equal power, the sum will be -3dBFS due to pan-law, bypass the
panner and you'll get +6dB
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 833 bytes
Desc: OpenPGP digital signature
More information about the Ardour-Users