[Ardour-Dev] Banking on a surface
Len Ovens
len at ovenwerks.net
Tue Jun 21 11:31:54 PDT 2016
Are there any opinions on how the top bank should be displayed on a
surface?
In the MCP code (Mackie Control) I set it so that the bank start was
always a mutiple of bank size. This means that after a bank, the left most
strip is always the next strip after the right most strip in the previous
bank. Some of the strips in the highest bank will therefore be
blank/unused.
The other way of doing things, is that the highest bank sets the rightmost
strip to the highest strip number and fills back from there. All the
strips are always used (so long as there are at least enough strips to do
so). SO far this how the OSC code works.
Those of you who use a control surface, do you find one way better than
the other? Does anyone use their control surface with another daw and find
Ardour does things different and that it is confusing switching back and
forth?
Probably both Surfaces should work the same, so I will change the one
people don't like.
--
Len Ovens
www.ovenwerks.net
More information about the Ardour-Dev
mailing list